Silvercrest SFS 150 B3 - Manual (Page 53)

50 SFS 150 B3
GB
MT
Sealing the tube fi lm
IMPORTANT
► For sealing use only fi lm made from HDPE (high density polyethylene) and
LDPE (low density polyethylene).
► The foil thickness must be between 30-50 μ (0.03 - 0.05 mm). Otherwise,
the sealing seam will not be tight and the appliance could be damaged.
You can identify fi lms of this kind from the markings on the packaging. The
quality of the seal varies depending on the type and thickness of the fi lm.
► Do not heat the supplied fi lm, for example in a water-bath or similar. It is
construed for temperatures up to a maximum of 60°C.
♦ Pull out the desired length of fi lm under the guide rail of the cutting
device .
♦ Press down on the cutting device and then slide it to the left or right over
the bag width. You get a clean cut with straight-cut corners.
♦ Open the appliance lid by pressing the lid releases to the top.
IB_96111_SFS150B3_LB5.indb 50 04.12.13 09:24