Silvercrest SWW 1500 B2 - Manual (Page 43)

SWW 1500 B2 41
4. Screw the feet 3 to the underside of the
appliance using the screws provided.
Insert 2 screws for each foot.
.
Warning! Check that there is
sufficient distance from the wall,
fixtures and other appliances.
When setting up on the floor, the
distance must be at least 0.5 m to
exclude the risk of fire.
5. Select a location in compliance with the
safety information (see “4. Safety
instructions” on page 37).
6. Operation
Notes:
• As the appliance and heating coils are
supplied with a thin film of grease, there
might be a small amount of smoke and
odour the first time the appliance is
used. This is not harmful and will stop
after a short time. Ensure adequate
ventilation during this process.
• If you have plugged other power
consumers into the same circuit, check
that the maximum load for the installed
fuse is not exceeded, as otherwise the
fuse will trip.
6.1 Turning the appliance on and off
1. Plug the mains plug into a power supply
socket which meets the technical data
requirements (see “3. Technical data”
on page 37).
The appliance is now ready to be used.
2. To turn off the appliance, turn the
temperature selector 6 to "MIN" before
removing the mains plug. This is the only
way to ensure that the appliance is
completely de-energized.
RP90993 Wärmewelle oWH LB2 Seite 41 Freitag, 9. August 2013 4:11 16