Euro-Pro CV520HY - Manual (Page 4)

GETTING TO KNOW YOUR CANISTER VACUUM TROUBLE SHOOTING GUIDE
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
Motor runs but no
suction
1. Hose, wand or inlet is
blocked.
2. Check bag full indicator.
3. Hose clamp not assembled to
hose inlet properly.
1. Check for blockage - remove it.
2. If dust bag is full, replace dust
bag or look for blockages in
system or vacuum.
3. Insert hose clamp into hose inlet
until "snap" locks for proper
assembly.
Cord does not
rewind
1. Cord twisted.
2. Cord pulled out too far -
beyond "RED" mark.
1. Pull cord out, straighten and
rewind again.
2. Holding the plug, press the
rewind button and try to rewind
again.
Cleaner won't run
1. Not firmly plugged in.
2. Blown
fuse/tripped breaker.
3. Motor thermostat may have
tripped.
1. Plug unit in firmly.
2. Replace fuse/reset breaker.
3. Allow unit to cool down before
trying to switch "ON" again.
ORDERING REPLACEMENT FILTERS & BAGS
TO ORDER REPLACEMENT FILTERS & BAGS
OR FOR TECHNICAL SUPPORT
FOR MODEL CV520HB/HR/HY
Call: 1 (800) 798-7398
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
8. Easy Glide Rear Wheel
9. Extension Tubes (x2)
10. Carpet / Floor Brush
11. Dust Bags (x2)
12. Flexible Hose
13. Manual Suction Control
1. On/Off Button
2. Handle
3. Cord Rewind Button
4. Full Bag Indicator
5. Cover
6. Cover Locking Tab
7. Air Intake Duct
IMPORTANT: DO NOT ATTEMPT TO WASH or REUSE DUST BAGS.
Always replace with new dust bag to keep your unit in maximum working
condition.
Please Note:
The Pre-Motor and Post-Motor Filter are washable. It should however be
replaced every Three (3) to six (6) months, depending on usage, to ensure
peak performance of your vacuum. Make sure that the Pre-Motor and
Post-Motor Filters are completely air-dried for 24 hours before inserting
back in the vacuum.
Technical Specifications
Voltage: 120V., 60Hz.
Power: 10 Amps
Illustrations may differ from actual product.
7
2