Silvercrest Electrical Sockets - Manual (Page 10)

10 GB
Setting-up operation / Cleaning
Prob-
lem No indicator light 1
on remote control
when pressing “ON”
or “OFF”
Rem-
edy · Check if the batteries are
inserted correctly.
· Check if the batteries
have proper contact with
the springs, if necessary
adjust.
Prob-
lem No reaction from
consumer
Rem-
edy · Check that the appliance
is switched on.
· Assign new code to the
remote control socket (see
„preparing the remote
control socket“, point 3).
· Check - by walking closer
to it - that the range is
correct for the desired
location.
Prob-
lem Range is too small
Rem-
edy · For large ranges, ensure
that as few walls and as
little furniture as possible
are in the way of the
remote control and the
radio-controlled socket.
· If the range is too small
at times, the reason could
be a remote control which
works on a similar frequen-
cy. Whenever this remote
control is active, the range
declines (e.g. wireless
headphones, radio-con-
trolled movement alarms,
radio gongs etc.).
Cleaning
Ensure that no liquids get into the
inside of the device. Use a soft cloth
to clean the housing. Never use
petroleum, solvents or cleaners
which corrode plastics.
Before cleaning, always disconnect
the radio-controlled socket from the
wall socket and remove all power
plugs from the device.
91210_silv_Funksteckdosen-Set_Content_DK.indd 10 18.07.13 10:13