Electrolux 318 200 687 - Manual (Page 7)

7
Getting S Getting Start art
GROUNDING INSTRUCTIONS
For personal safety, the cooktop must be properly grounded. For
maximum safety, the power cord must be plugged into an
electrical outlet that is correctly polarized and properly grounded.
DO NOT operate the cooktop using a 2-prong adapter or an
extension cord. If a 2-prong wall receptacle is the only available
outlet, it is the personal responsibility of the consumer to have it
replaced with a properly grounded 3-prong wall receptacle
installed by a qualified electrician.
See the INSTALLATION INSTRUCTIONS packaged with this
cooktop for complete installation and grounding instructions.
LIQUEFIED PETROLEUM (PROPANE) GAS
CONVERSION
This appliance can be used with Natural Gas and Propane Gas. It is shipped from the
factory for use with natural gas.
A kit for converting to LP gas is supplied with your cooktop. The kit is marked “FOR LP/
PROPANE GAS CONVERSION”. Follow the installation instructions which are inside the
envelope.
The conversion must be performed by a qualified service technician in accordance with
the kit instructions and all local codes and requirements. Failure to follow instructions
Do not, under any
circumstances, cut,
remove, or bypass the
grounding prong.
Power supply cord with
3-prong grounding plug
Grounding
type wall
receptacle
!
WARNING WARNING WARNING WARNING WARNING
This appliance is equipped with a 3-prong grounding plug for your protection
against shock hazard and should be plugged directly into a properly
grounded receptacle. DO NOT cut or remove the grounding prong from this
plug.
Avoid fire hazard or electrical shock. DO NOT use an adapter plug, an
extension cord, or remove grounding prong from electrical power cord.
!
WARNING WARNING WARNING WARNING WARNING
Severe shock, or damage to the cooktop may occur if the cooktop is not installed by a qualified installer or
!
CA CA CA CA CAUTION UTION UTION UTION UTION
Any additions, changes or conversions required in order for this appliance to satisfactorily meet the
application needs must be made by a qualified service technician in accordance with the manufacturer’s
instructions and all codes and requirements of the authority having jurisdiction. Failure to follow the
instructions could result in serious injury or property damage. The qualified agency performing this work
assumes responsibility for the conversion.