Silvercrest SHBR 100 A2 - Manual (Page 21)

25 GB
Safety system / Preparations for use
Safety system
Note: the heating pad is equipped with a safety
system. The electronic sensor technology prevents the
entire surface of the heating pad from overheating
by automatically switching off in the event of a fault.
If the safety system switches the heating pad off auto-
matically due to a fault, then the function display
2
on the control unit 1 is no longer illuminated, even
if the heating pad is switched on.
Please note that, for safety reasons, the heating
pad must not be used after a fault and must be
returned to the service address indicated.
Preparations for use
Note: the heating pad may smell of plastic the
first time you use it, but this will disappear after a
short period of time.
To begin, first connect the control 1 to the
heating pad with the plug-in connector 3
(see fig. B).
Position the heating pad according to your
individual requirements on your back or stomach
(see fig. C).
Wind the long, extendible rubber band around
your body.
Then fix the heating pad to your body by
connecting the Velcro fasteners of the heating
pad with the Velcro fasteners of the rubber
band (see fig. D).
Switching on / off / Selecting
the temperature
Switching on:
Set Level 1, 2, 3, 4, 5 or 6 on the control 1 to
switch the heating pad on.
Note: The function display 2 illuminates after the
heating pad is switched on.
Note: this heating pad features rapid heating,
which allows it to heat up within the first 10 minutes
of operation.
Switching off:
Set Level 0 on the control 1 to switch the
heating pad off.
Note: the function display 2 ceases to illuminate.
Selecting the temperature:
Just before using the heating pad, set it to the
highest temperature setting (level 6). This will
cause the heating pad to warm up quickly.
If you wish to leave the heated pad on for several
hours, set the lowest temperature (level 1).
Temperature levels
Set the required temperature level on the
control 1 (see fig. A).
Level 0: off
Level 1: minimum heat
Level 2–5: customised settings
Level 6: maximum heat
Automatic switch-off
Note: The heating pad switches itself off automati-
cally after about 90 minutes. The function display
2
then starts to flash.
Then select the setting “0” and after about
5 seconds, reset the heating pad to the desired
temperature setting to switch it on again.
Switch the heating pad off (setting “0”) if
the heating pad is not to be used after it has
switched itself off automatically.