Silvercrest SSM 550 C1 - Manual (Page 41)

- 38 -
Cleaning the mixer
➩
So that you do not injure yourself on the cut-
ters r , clean the mixer jug e only with a long
handled dishwasher brush.
➩
In a case of stubborn soiling, the mixer jug e
can also be cleaned in a dishwasher. For this,
always take the mixing jug
e apart, as
described later.
➩
Clean the cover w and the filling cap q in a
dishwasher or with the normal washing up.
If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
➩
Fill the mixer jug e with 750 ml of water and
add a few drops of mild detergent. Close the
cover
w and fit the mixer jug e onto the motor
block u .
Insert the plug into a mains power socket and
activate the Ice Crush/Clean operation a few ti-
mes, such that the cutting blade
r ploughs
through the water at full speed.
Afterwards, rinse the blender
e out with lots of
clean water to ensure that all detergent residues
have been removed.
Should this not dislodge the soiling, you can separate
the lower plastic part of the mixer jug
e (with the cut-
ters r ) from the the glass part:
Glass element
Sealing ring
Cutting blade
Plastic element
➩
Remove the mixer jug e from the motor block
u .
➩
Turn the plastic element
of the mixer attach-
ment e anti-clockwise, such that it allows itself to
be released from the glass element
.
Attention!
Take care with the cutters
. They are very sharp.
Risk of injury!
➩
Clean both parts thoroughly in a mild soapy
solution or in a dishwasher.
➩
Replace the plastic element
of the mixer jug
e
back onto the glass element
. Ensure that the
sealing ring
is correctly fitted.
IB_86045_SSM550C1_LB2 06.12.2012 15:51 Uhr Seite 38