Silvercrest SRR 800 A1 - Manual (Page 50)

SilverCrest SRR 800 A1
48 - English
Cleaning / maintenance
Cleaning
Unplug the shaver from the mains power supply before cleaning as
there is a risk of an electric shock!
Switch off the shaver before cleaning it in order to avoid hazards.
Never immerse the shaver in water or other liquids. Otherwise, liquid
will penetrate it because the casing is not watertight.
Do not use compressed air, scouring pads or corrosive cleaning
agents to clean the shaver.
The shaving foil [2] must not be cleaned with the cleaning brush
because this would damage the shaving foil [2].
It is recommended that the shaver is cleaned after each use to achieve
optimal shaving results.
Only use a clean, slightly damp cloth to clean the casing of the shaver and
never use any corrosive liquids.
Remove the protective cover [1]. Press both sides of the release [5] and
remove the shaving foil frame [3]. Tap the shaving foil frame [3] out on to
a flat surface. Then clean the cutter block [4] and around it with the
cleaning brush. Put the shaving foil frame [3] and then the protective cover
[1] back on after cleaning.