Setting up and connecting, Disposal of the packaging, Set-up location requirements – Silvercrest SKRI 2000 A1 User Manual
Page 84: Electrical connection, Gb mt

81
Setting up and connecting
SKRI 2000 A1
GB
MT
Disposal of the packaging
The packaging protects the appliance from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material and
reduces the amount of waste generated. Dispose of packaging material that is
no longer needed as per the regionally established regulations.
NOTICE
If possible preserve the original packaging during the warranty period so
►
that, in the event of a warranty claim, you can repackage the appliance
ideally for its return.
Set-up location requirements
For the safe and fault free operation of the appliance, the installation location
must fulfi ll the following conditions:
When setting the appliance up, place it on a fi rm, fl at and even surface.
■
Use the hinged foot-pads.
Set up or mount the appliance in such a way that the extant ventilation open-
■
ings and the speaker are not covered.
Do not operate the appliance in a hot, wet or very humid location or in the
■
vicinity of fl ammable materials.
Do not install the appliance directly over a hotplate.
■
The mains power socket must at all times be easily accessible, so that the
■
plug can be easily and quickly removed if necessary.
Electrical connection
The appliance is powered with a DC voltage of 7V via the supplied power
■
adapter. Connect the appliance to the mains power supply only via the
supplied power adapter.
Before connecting the appliance compare the connection data (Voltage
■
and frequency) on the rating plate with that of your mains electric source.
To avoid potential damage to the appliance this data must concur.
Protect the connection cable against hot surfaces and sharp edges.
■
Ensure that the connection cable is not tightly stretched or kinked.
■
Do not allow the connection cable to hang over edges (Tripwire eff ect).
■
If you do not intend to use the appliance for an extended period, disconnect
■
the plug from the mains power supply.
IB_63920_SKRI2000A1_LB5.indb Abs3:81
17.01.2012 11:32:37 Uhr