Switching on/oﬀ / selecting a heat level, Styling, Removing attachments – Silvercrest SWC 300 B1 User Manual

Page 47: Gb mt

SWC 300 B1

GB
MT

Removing attachments

■

First switch the appliance oﬀ and allow it to cool down..

■

Pull the attachment from the attachment insertion slot 1.

Switching on/oﬀ / Selecting a heat level

■

When you have inserted the required attachment and connected the plug
with the mains power socket, you can now switch the appliance on with the
level switch 3 and select the output level:

–

"0"

The appliance is switched oﬀ

–

"C"

for a cold air stream (Cool Shot)

–

"1"

for a warm air stream

–

"2"

for a hot air stream

■

You switch the appliance oﬀ by sliding the level switch 3 to the position "0"
(= appliance oﬀ ).

■

To ﬁ x the styling, you can move the level switch 3 to "C". The styling will be
ﬁ xed by the cool air stream.

Styling

Select the desired attachment:

–

for long hair and large curls the large styling brush 4.

–

for shorter hair or small curls the small styling brush 8.

■

Wind the slightly damp strand of hair around the selected styling brush 4/8.

■

Switch the appliance on at level 1 or 2.

■

When the strand is dry, slide the level switch 3 to "C". Wait until the strand
has cooled.

■

Press the roll-out button 2 and simultaneously pull the appliance downwards
out of the strand. The styling brush 4/8 rotates with it, so that unwinding
the strand can be done easily.

■

Proceed with the other strands in the same way.

IB_60488_SWC300B1_LB5.indb 44

24.04.14 10:54

This manual is related to the following products:

SWC 300 A1