Silvercrest SSR 10 A1 - Manual (Page 69)

SilverCrest SSR 10 A1
English - 67
 To deactivate the alarm function, briefly press the "PRESET"
button (7) until no alarm symbol (12,13) is indicated on the
display (1). The alarm function is then deactivated.
 The device wakes you at the set alarm time with a signal tone.
On the display (1), the corresponding alarm symbol (12,13)
flashes during this time. The alarm will sound for approx. 60
seconds followed by a 60 second pause. This continues until
the alarm is turned off. To switch off the alarm tone, briefly
press the "On/Standby" button (6). The alarm is then
deactivated until the next day.
Please note that the signal tone is played via the built-
in buzzer of the scan radio and not via the
earphones.
SNOOZE function
 To pause the alarm tone for approx. 5 minutes, briefly press
the "MODE" button (3) during the signal tone. During these 5
minutes, the corresponding alarm symbol (12,13) flashes on
the display (1) and the "SNOOZE" symbol (15) is indicated.
 After approx. 5 minutes, the alarm tone starts again. To switch
off the alarm tone, briefly press the "On/Standby" button (6).
Troubleshooting
No sound / no reception
 Check whether the earphones (B) are inserted correctly into
the earphone jack (8).
 Check whether the volume is set too low.