beautypg.com

Cleaning, 8 thermal cut-out, 9 safety switch – Silvercrest SHLF 2000 A1 User Manual

Page 48

background image

46

2. To switch the swivel function off, press

the swivel function button 17 or 21
again.

6.8 Thermal cut-out

For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Switch the mains switch 8 to 0 to switch

off the appliance.

2. Check whether the air inlet or outlet is

obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or else take it out of
use.

3. Wait for the appliance to cool down.
4. You can then continue to operate it

normally.

6.9 Safety switch

The appliance is protected against
accidental damage by a safety switch.
The safety switch is
located on the bottom
of the appliance and
switches the appliance
off immediately should
it fall over:

1. Return the appliance to an upright

position.

2. Select the required function again (see

“6.1 Displays” on page 44).

7. Cleaning

To ensure your appliance gives you lasting
service, you should clean it regularly.

Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before

each clean;

– allow the appliance to cool

down;

– never immerse the appliance in

water;

– never allow water or cleaning

agent to run into the appliance.

1. Carefully remove major dust deposits

from the protective guards with a
vacuum cleaner.

2. Remove any remaining dirt with a soft

brush.

Take care not to let any dust fall inside
the appliance. You should therefore hold
the appliance so that the protective
guard you are in the process of cleaning
is facing downwards.

3. Clean the outside of the appliance with

a damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.

4. Wipe the appliance with a cloth

moistened with clear water.

5. Do not use the appliance again until it

has dried completely.

RP89886 Heizlüfter mit LCD und FB LB2 Seite 46 Freitag, 24. Mai 2013 2:39 14