Silvercrest SNM 33 B1 - Manual (Page 88)

88 GB / IE
Monogramming and embroidering with embroidery hoop*
Stitch Stitch width Stitch length
B 1~5 0
Stitch Stitch width Stitch length
B 3~5 0.5~1
Applique
* Embroidery hoop not included with machine.
1. Cut out the applique design and baste it
to the fabric.
2. Sew slowly around the edge of the
design.
3. Trim excess material outside the
stitching. Make sure not to cut any
stitches.
4. Remove the basting thread.
5. Tie top and bottom thread under the
applique to avoid unraveling.
Sewing basics
Attach the embroidery and darning plate
Preparation for Monogramming and
Embroidering*
1. Remove the presser foot and the presser
foot holder.
2. Attach the embroidery and darning plate.
3. Lower presser foot lever before starting
to sew.
4. Adjust the stitch width according to the
size of lettering or design.
1. Draw the desired lettering or design on
the right side of the fabric.
2. Stretch the fabric between embroidery
hoop as firmly as possible.
3. Place the fabric under the needle. Make
sure the presser foot bar is down in its
lowest position.
4. Turn the hand wheel towards you to
bring up the lower thread through the
fabric. Sew a few securing stitches at the
starting point.
5. Hold the hoop with thumb and
forefingers of both hands.
6. Coordinate sewing speed and movement
of hoop.