Elta 4248N User Manual
Page 7
POWER SOURCE
The unit operates with mains power supply. Clock and alarm with DC back-up, battery: 1 x 9V (not included).
AC POWER SUPPLY
Ensure that the AC power cord is in accordance with your local voltage cord and connect to mains power supply. Press the
POWER button to turn on the unit.
BACK-UP BATTERY
Insert a 9V battery (not included) into the battery compartment located at the bottom; preferably use a long-life battery.
In case of power failure when listening to the radio it will switch off and the display will show a wrong radio frequency,
because the CPU cannot receive any signals from the radio. After the power failure the radio frequency will be restored
to the last frequency and continue working.
RADIO FUNCTION
1. Set the FUNCTION SELECTOR (MODE) to ON.
2. Select desired band with the BAND SELECTOR.
3. Rotate the TUNING control to find your desired radio station.
4. Adjust the VOLUME to a comfortable level.
5. For better reception extend the FM wire antenna to its full length when listening to FM or adjust the direction
when receiving AM.
6. To switch off the radio set the FUNCTION SELECTOR (MODE) to OFF.
TIME SETTTING
Press and hold the TIME SET button and simultaneously press SLOW SET or FAST SET to skip to the correct time.
Notes:
Press SLOW SET button each time to skip one minute, press and hold the button to skip continuously.
Press and hold FAST SET button to skip fast and continuously.
ALARM SETTING
Note: You can set two different alarm times on this unit.
1. Press and hold either the AL 1 or AL 2 button, then press the SLOW SET/FAST SET button to skip to the desired
alarm time.
2. Set the FUNCTION SELECTOR (MODE) to AUTO.
3. Set the ALARM switch to AL 1 or AL 2 (for one alarm) or AL 1+2 (for two alarms), the corresponding indicator
will illuminate.
At the preset alarm time the alarm will set on the radio automatically. To pause the alarm and sleep another 9 minutes
press the SNOOZE button.
4. To stop the alarm, slide the FUNCTION SELECTOR (MODE) to OFF or press AL OFF.
SLEEP FUNCTION
To switch off the radio automatically after 59 minutes slide the FUNCTION SELECTOR (MODE) to AUTO and press SLEEP.
After 59 minutes the radio will switch off automatically.
At the preset alarm time you will be woken by radio.
SPECIFICATIONS
Power supply
230V~ 50Hz
(check the rated power on rating plate at the bottom of the device)
Back-up 9V DC
Power consumption
3W
Operating temperature
+5ºC - +35ºC
Receiving Bands
AM/FM
Tuning Range
AM: 525 - 1615kHz
FM: 87.5 - 108MHz
Speaker impedance
8Ω
NET WEIGHT:
537g
Specifications are subject to change without prior notice.
7.