Silvercrest SWKCD 3000 A1 - Manual (Page 11)

9 SWKCD 3000 A1
GB
Removing/replacing the pourer sieve
1) Open the lid.
2) Pull the pourer sieve 6 upwards out of its holder.
3) Clean the pourer sieve 6 with a lightly moistened dishcloth and under running
water.
4) After cleaning it, replace the pourer sieve 6. Ensure that the restraint
engage and that the pourer sieve 6 is fi rmly seated.
NOTICE
► Should the scale deposits in the pourer sieve 6 be fi rmly established, lay
it in a water-vinegar solution having a ratio of 6:1 for a few hours. The
scale deposits will dissolve themselves. Rinse the pourer sieve 6 with lots
of clear water.
Storage
■ Allow the appliance to cool down completely before putting it into storage.
■ Wind the power cable around the cable winder 4 under the base 3.
■ Store the appliance at a dry location.
Troubleshooting
Problem Cause Remedy
The appliance
does not function.
The plug is not inserted into
a mains power socket. Insert the plug into a
mains power socket.
The appliance is not
switched on.
Switch the appliance on.
The appliance is defective.
In this case, contact
Customer Services.
The ON/OFF
switch 2 does
not engage.
The kettle is not on the
base 3. Place the kettle on the
base 3.
The appliance is defective.
In this case, contact
Customer Services.
Buch_72059_LB4.indb 9 Buch_72059_LB4.indb 9 30.03.12 10:23 30.03.12 10:23