Silvercrest STOD 1500 A1 - Manual (Page 46)

43 STOD 1500 A1
GB
MT
Setting up
■ Unwind the cable from the cable retainer 5 on the bottom of the appliance
and feed the cable through one of the side clips.
■ Place the appliance on a dry and level surface.
■ Insert the plug into a mains power socket.
Before taking into use
■ Operate the toaster without bread for 3 times at the maximum browning
level (IIIII).
■ Afterwards, clean the toaster as described in the chapter “Cleaning”.
NOTICE
► The operating slide 3/9 only engages when the cable is connected to a
mains power socket.
► With the fi rst usage a slight smell can arise (minimal smoke development is
also possible). This is normal and dissipates after a short time. Provide for
suffi cient ventilation. For example, open a window.
Operation
NOTICE
► The setting for the browning level, the activation of the defrost or reheat
function, and also the stop function all apply to all 4 toasting slots 2!
Only the start of the toasting process can be restricted to two toasting slots
by using the respective operating levers 3/9.
Adjusting the browning level
The desired level of browning, from “light” (I) to “dark” (IIIII), can be adjusted
infi nitely with the toasting dial 7.
NOTICE
► Take note that, subject to the demand made on the toaster, the level of
browning can vary somewhat with an unvarying adjustment of the toasting
dial 7! The less the number of slices inserted, the higher is the browning
level. Thus, if you are not intending to toast many slices, always set the
toasting dial 7 a little lower.
IB_39995_STOD1500A1_LB5.indb 043 IB_39995_STOD1500A1_LB5.indb 043 12.03.14 13:05 12.03.14 13:05