Silvercrest SKD 1000 A3 - Manual (Page 27)

Cassette Digitizer SilverCrest SKD 1000 A3
English 25
Conformity Notice
This device complies with the basic and other relevant requirements of EMC
Directive 2004/108/EC and the RoHS II Directive 2011/65/EU. The declaration
of conformity can also be found at the end of this user manual.
Troubleshooting
You can solve most common problems yourself using the table below. If the problem persists
after checking the suggested solutions, please contact our Service Hotline (see page 27). Do not
attempt to repair the product yourself.
The cassette digitizer can’t be switched on
 Insert the batteries with the correct polarity.
 Replace the batteries.
 If you are using an optional mains adapter, connect the adapter firmly to the DC input (1) of
the device and to a properly-functioning power socket. Make sure that the small round
connector of the mains adapter has the correct polarity (
) and that the mains adapter
outputs 3 V DC.
No sound
 Are you sure the inserted cassette contains recordings?
 Is the volume set to very low?
Problems when copying cassette content to a computer
 Please check that the USB cable is properly connected.
 Make sure that the USB cable is not damaged.
 Make sure that the correct recording console is configured in the AudioLava software. Select
"Options", then "Device Settings", and in "Recording Console" select the "[MME]