Silvercrest SAS 150 A1 - Manual (Page 10)

10 GB
Q Cleaning and maintenance
Q Cleaning
Important safety advice for
cleaning the slicer
1. Before starting to clean the electric Multi-Pur-
pose Slicer; switch it off, remove the power ca-
ble
8 from the mains socket and set the food
support plate 13 into the “0“ setting.
2. Do not submerse the electric Multi-Purpose
Slicer in water.
3. ATTeNTION! RISk OF SeRIOUS
INjURy: The cutting blade 12 is very sharp!
Accessories suitable
for dishwashers!
Clean the food carriage 10 , the food holder
plate 11 , the cutting blade 12 and the slice
tray 17 in the dishwasher.
It is necessary to clean the electric Multi-Pur-
pose Slicer thoroughly at regular intervals as
perishable food scraps could accumulate on
the appliance or behind the cutting blade
12 .
Clean all appliance parts not suitable for the
dishwasher with a lightly moistened cloth.
Wipe off the appliance housing
5 , the cutting
blade covering 6 , the support table with
guide slots 9 and the food support plate 13
carefully. Do not use abrasive cleaning agents,
sponges with rough surfaces or hard brushes.
Cleaning brush:
ATTeNTION! RISk OF peRSONAL INjU-
Ry! Carry out all tasks using the cleaning brush
19 (see Fig. F) with great care. Should it slip
close to the cutting blade 12 , there is the risk
of receiving a severe personal injury.
Use the bristles of the cleaning brush 19 to re-
move remnants such as crumbs from all difficult
to reach positions. The flattened end can be
excellently used to remove stubborn soiling.
Q Maintenance / Removing /
assembling the cutting blade
Important safety notices for
the removal and assembly of
the cutting blade!
1. Switch the slicer off, remove the plug from the
power socket and set the food support plate 13
into position “0“.
2. ATTeNTION! RISk OF peRSONAL
INjURy! The cutting blade 12 is very sharp!
For the removal and assembly wear appropriate
safety gloves. Otherwise, you could receive cut
injuries.
Open the blade cover 6 by pressing the
blade cover unlock button 4 . Remove the
blade cover 6 .
Remove the plastic screw clip 18 from the
mounting (see Fig. E) and screw the blade lock
of the cutting blade
12 out by unscrewing it to
the left.
When taking out the blade 12 make sure that
you grasp it at its centre.
The cutting blade 12 can be cleaned in the
dishwasher.
Clean the housing behind the cuttingblade 12
with a dry cloth or a soft brush.
Re-assemble the cutting blade 12 in a reverse
sequence of the above instructions.
Due to the special sawtoothing and the high
quality, the cutting blade
12 will retain its
sharpness for a very long time. A resharpening
of the cutting blade is not necessary. Consult
the service centre for your country if you have
questions about the cutting blade
12 .
Q Special accessories
Round cutter:
An untoothed cutting blade, specifically for the
finest of slices, is also available.
Orders for special accessories are be directed to
the service centre for your country.
Warranty / Customer Service / Disposal / Declaration of Conformity / Manufacturer Cleaning and maintenance