Silvercrest SAB 160 A1 - Manual (Page 178)

174
Initial use
SAB 160 A1
GB
Initial use
Face plate
To protect against theft you can remove the face plate from your device. Do not
store the removed face plate in your vehicle.
NOTICE
► When the face plate is not inserted into the frame the theft protection
LED
31 on the device blinks.
► To safeguard the face plate always keep it stored in its case.
Installing the face plate
♦ Place the face plate with the left side in the
frame fi rst.
♦ Then fi rmly press the right side until it locks into
place.
♦ Subsequently fl ip the face plate upwards until it
locks into place.
Check to make sure that the face plate is fi rmly and
correctly installed in the frame. If the face plate
is incorrectly installed it can result in malfunctions
when operating the device.
Removing the face plate
♦ Press the button to unlock the face plate.
The face plate tilts automatically forward.
♦ Slide the face plate to the left and then pull fi rst
the right and then the left side away.
Buch_75726_LB1.indb 174 27.06.12 11:19