beautypg.com

What to do if, Troubleshooting by yourself – Electrolux LAVATHERM T35850 User Manual

Page 14

background image

What to do if ...

Troubleshooting by yourself

Problem

Possible cause

Remedy

Dryer does not work.

Mains plug is not plugged in or

fuse is not working correctly.

Plug in at mains socket. Check

fuse in fuse box (domestic in-

stallation).

Loading door is open.

Close loading door.

Have you pressed the START

PAUSE button?

Press the START PAUSE button

again.

Drying results unsatisfactory.

Wrong programme selected.

Select a different programme

the next time you dry (see “Pro-

gramme chart” chapter).

Filter clogged.

Clean filter.

Overloading of laundry.

Observe recommended loading

volumes.

Ventilation slots covered up.

Uncover ventilation slots.

Residue on inside surface of

drum or drum ribs.

Clean inside surface of drum

and drum ribs.

Conductance of water at in-

stallation site differs from

standard setting of machine.

Re-programme standard set-

ting for degree of drying (see

‘Programming options’ chap-

ter).

Loading door does not close.

Filter not in place.

Install filter into place.

Drum light does not work.

Programme selector in OFF po-

sition.

Turn programme selector to

LIGHT or to any programme.

Defective light bulb.

Replace light bulb (see next

section).

Drying cycle ends shortly after

programme starts.

Not enough washing loaded or

washing loaded is too dry for

selected programme.

Select time programme or

higher drying level (e.g. EXTRA

DRY instead of STORAGE DRY).

Drying cycle lasts an unusually

long time. Note: After around 5

hours the drying cycle ends au-

tomatically.

Filter clogged.

Clean filter.

Load volume too big.

Reduce load volume.

Laundry insufficiently spun.

Laundry must be adequately

spun.

Particularly high room temper-

ature. Temporary switching off

of the compressor to avoid

overload.

Automatic process, there is no

fault with the appliance. If pos-

sible, lower the room tempera-

ture.

14

What to do if ...