Silvercrest SHT 2000 A1 - Manual (Page 51)

SHT 2000 A1 49
1. To switch on the timer, press the timer
button 12 or 19.
The display shows
00:00 and the hours
flash.
2. Press the “+” button 14 or 18 to
increase the hours.
3. Press the “-” button 15 or 17 to reduce
the hours.
4. Press the timer button 12 or 19 again.
The minutes flash.
5. Press the “+” button 14 or 18 to
increase the minutes.
6. Press the “-” button 15 or 17 to reduce
the minutes.
7. Press the timer button 12 or 19 again to
activate the timer.
The selected operating time is shown in
the display 10.
As soon as the set operating time has
expired, the appliance switches off
automatically.
8. To switch off the appliance while the
timer is active, press the On/Off button
16 or 22.
6.7 Swivel function
The appliance has a swivel function.
This causes the appliance to swivel to and
fro, distributing the exiting air more evenly
through the room:
1. To switch the swivel function on, press
the swivel function button 13 or 20.
2. To switch the swivel function off, press
the swivel function button 13 or 20
again.
6.8 Thermal cut-out
For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Switch the mains switch 5 to “OFF” to
switch off the appliance.
2. Check whether the air inlet or outlet is
obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or else take it out of
use.
3. Wait for the appliance to cool down.
4. You can then continue to operate it
normally.
If the room temperature exceeds 50 °C, the
thermal cut-out also switches the appliance
off automatically. The appliance can then
only be switched on again once the room
temperature has dropped below 50 °C.
6.9 Safety switch
The appliance is protected against
accidental damage by a safety switch.
The safety switch is located on the bottom of
the appliance and switches the appliance off
immediately should it fall over:
1. Return the appliance to an upright
position.
2. Select the required function again (see
“6.1 Displays” on page 47).
RP75978 Heiztower LB5 Seite 49 Mittwoch, 29. August 2012 5:51 17