Silvercrest SWKD 3000 A1 - Manual (Page 7)

- 5 -
Keeping water hot
With this kettle you can maintain the water at a
temperature of (about) 40°C, 60°C, 80°C or
100°C for 30 minutes. Should you have set the
desired temperature maintenance at 100°C, to
avoid excessive steam development the kettle holds
the water at a temperature of between about 90°C
and 100°C. If the desired heating maintenance
temperature is 80°C, 60°C or 40°C, the water he-
ater holds the water at a temperature of between
about 8°C above or below the selected temperature.

Important
Use the keep-warm function only when there is at
least 0.5 liters of water in the kettle. If there is less
water in it, the kettle may be switched off within the
30 minutes in order to protect the heating element.

Warning
BEFORE you lift the kettle from the base y , first
disconnect the plug from the mains power socket. This
prevents causing a short circuit by water possibly spil-
ling out of the kettle and falling onto the live
electrical connections in the base
y .

Risk of personal injury
For safety reasons, the lid should not be opened
while the water is boiling or is very hot. There is
a risk of receiving severe scalds.
The keep-warm setting can be made before, during
or immediately after the boiling process:
Information
If you cannot set the desired temperature, it may be
because the temperature of the water in the kettle is
still too high.
B Be effo orre e tthhe e b bo oiilliinng g p prro occe essss
• Before the boiling process, press the KEEP
WARM w button.
• Press the button SET TEMP r repeatedly until
the LED q at the desired temperature glows.
• Press the button Start to begin the boiling and
then the keep-warm process.
The LED q of the currently set temperature glows,
the LED integrated in the KEEP WARM w button
glows as well as the LED in the On/Off e button.
The water will now also be kept warm after being
heated.
D Duurriinng g tthhe e b bo oiilliinng g p prro occe essss
• Start the boiling process as described in the
section "Heating water".
• During the boiling process, press the KEEP
WARM w button.
On completion of the boiling process the LED q of
the currently set temperature glows, the LED integra-
ted in the KEEP WARM
w button glows as well as
the LED in the On/Off e button.
The water will now also be kept warm after being
heated.
A Afftte err tthhe e b bo oiilliinng g p prro occe essss
• After the signal tone, indicating the end of the
boiling process, press the button KEEP
WARM
w .
The appliance will then automatically maintain the
keep-warm temperature at the temperature you
selected to heat the water. The LED
q of the cur-
rently set temperature glows, the LED integrated
in the KEEP WARM
w button glows as well as the
LED in the On/Off e button. The water will now
be kept warm.
IB_67146_SWKD3000A1_LB6 29.06.2011 9:34 Uhr Seite 5