Silvercrest SSM 550 A1 - Manual (Page 10)

- 8 -
If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
³
Fill the liquidiser e with 750 ml of water and add
a few drops of mild detergent. Close the lid w
and place the liquidiser e on the motor block u .
Insert the plug into a mains power socket and
activate the Ice Crush/Clean switch a couple of
times, causing the cutters
r to plough through
the water with maximum revolutions.
Afterwards, rinse the liquidiser
e out with lots of
clear water, so that all detergent residues are re-
moved.
Should this not dislodge the soiling, you can separate
the lower plastic part of the mixer jug
e (with the cut-
ters r ) from the the glass part:
³
Remove the mixer jug e from the motor block
u .
³
Turn the plastic element
 of the mixer attach-
ment e anti-clockwise, such that it allows itself to
be released from the glass element
.
Attention!
Take care with the cutters
. They are very sharp.
Risk of injury!




³
Clean both parts thoroughly in a mild soapy
solution or in a dishwasher.
³
Replace the plastic part
 of the mixer jug
e
back onto the glass part
. Ensure that the sea-
ling ring
 is correctly fitted.
Cleaning the motor block
³
Use a dry cloth or, at the most, a lightly moistened
one for cleaning the plastic surfaces.
³
At every cleaning check that the contact switch
in the receptor for the mixer jug
e is not blok-
ked by soiling residues. If you cannot dislodge
any blockages with the corner of a piece of pa-
per, make contact with Customer Services. Un-
der no circumstances should you use a hard ob-
ject, this could damage the contact switch.
³
Remove any possible residues on the underside
of the motor block
u only with a dry cloth or a
stiff bristled brush. Ensure that nothing can enter
through the ventilation opening of the appliance.
After cleaning
Allow all parts to dry well before re-assembling and
re-using the liquidiser.
Storage
³
If you do not intend to use the liquidiser for an
extended period, clean it thoroughly (see chapter
"Cleaning").
³
Wrap the power cable y around the cable sto-
rage i on the base of the motor block u .
³
Store the liquidiser at a cool and dry location.
IB_66711_SSM550B1_LB4 28.04.2011 13:39 Uhr Seite 8