Silvercrest SFW 350 C1 - Manual (Page 64)

61
GB
MT
SFW 350 C1
5) Place your selected cutting disc 9 into the meat grinder casing 5 so that
the fi xings on the cutting disc 9 are located in the openings in the meat
grinder casing 5.
6) After everything has been correctly assembled, screw the ring clamp 0
back on hand-tight.
7) The ready-assembled meat grinder casing 5 is connected by a bayonet
connector to the motor block 4:
– Insert the meat grinder casing 5 into the motor block 4 such that the
arrow on the meat grinder casing 5 lies against the symbol
on the
motor unit 4. The locking button r presses itself in (Fig. B).
– Lightly press the meat grinder casing 5 in and at the same time turn
the feeding shaft on the meat grinder casing 5 into the middle position
(Fig. B) so that the arrow on the feeding shaft points to the symbol
.
When the meat grinder casing 5 engages, the locking button r
springs out.
– Finally, place the feeding tray 3 on top of the feeding funnel.
– To dismantle it, press the locking button r and turn the feeding funnel
to the right (Fig. B)
. You can now pull the meat grinder casing 5 out.
Assembling the sausage stuff er attachment
Unfold the fold-out side - there you will fi nd the step-by-step illustrations for as-
sembling the appliance.
1) Remove the meat grinder casing 5 as described under “Assembling the
meat grinder”.
2) Dismantle all parts which are fi tted to/in the meat grinder casing 5 and
clean them.
3) Coat all metal parts with cooking oil.
4) Put the transport screw 6, the spring 7 and the cross blade 8 back into
the meat grinder casing 5.
5) Insert the sausage disc w so that the fi xings on the sausage disc w are
located in the openings in the meat grinder casing 5.
6) Then place the sausage stuff er attachment q before the sausage disc w.
7) Screw the ring clamp 0 on hand-tight.
8) Assemble the meat grinder casing 5 as described under “Assembling the
meat grinder”.
IB_103776_SFW350C1_LB5.indb 61 15.10.14 13:11