Electrolux 79301 KF-MN - Manual (Page 14)

14
Residual Heat Indicator
When an individual cooking zone or the entire hob is
switched off, any residual heat is shown with an
h (for
“Hot”) in the digital display for the appropriate cooking
zones.
Even after the cooking zone has been switched off, the
residual heat indicator only goes out when the cooking zone is cold.
2
You can use the residual heat for melting and keeping food warm.
1
Important! As long as the residual heat indicator is illuminated, there
is a risk of burns.
1
Important! If the power supply is interrupted the
h symbol will also
go out and information about residual heat will no longer be available.
However, it is still possible to burn yourself. This can be avoided by tak-
ing care around the hob.
Cooking using the automatic warm up function
All of the cooking surface’s four cooking zones can be adjusted to any
of nine settings, and are equipped with an automatic warm up func-
tion:
–
¿, lowest heat setting
–
Ç, highest heat setting
–
a, automatic warm up function.
When you select the desired heat setting using the heat setting se-
lector sensor panel, the cooking zone will operate at maximum power
for a certain period of time and will then automatically switch back to
the follow-on heat setting that has been set.
The length of time that the automatic warm up function operates de-
pends on the follow-on heat setting selected.
1. Touch the heat setting selector sensor panel to set the desired heat
setting from
¿ to Æ. The heat setting that has been set will then be
displayed. After a period of 5 seconds, the
a (=automatic warm up
function) will appear in the display in place of the heat setting.
After