Silvercrest SKD 2300 A1 - Manual (Page 12)

10
7. Cleaning
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits
from the protective guards with a
vacuum cleaner.
2. Remove any remaining dirt with a soft
brush.
3. Clean the outside of the appliance with a
damp cloth. You could also use a little
washing-up liquid.
Caution!
Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
4. Wipe the appliance with a cloth
moistened with clear water.
5. Do not use the appliance again until it
has dried completely.
8. Troubleshooting
Fault Cause Remedy
Appliance cannot be
switched on Faulty fuse or wall socket Select another wall socket
Faulty appliance Have repairs carried out at a specialist
workshop or dispose of the appliance.
You will find the service address in
“Service Centre” on page 13.
Appliance switches
off automatically Thermal cut-out has
triggered Allow the appliance to cool down (see
“6.5 Thermal cut-out” on page 9)
Clean the appliance (see “7. Cleaning”
on page 10)
Only cold air is
produced Selected temperature has
been reached Appliance switches on again
automatically as soon as the room
temperature falls
Select a higher desired temperature
RP74308 Konvektor LB4 Seite 10 Mittwoch, 16. Mai 2012 3:20 15