Electrolux 50500 - Manual (Page 22)

Operating Instructions
22
Starting the Wash Programme
0 1. Check that when the dishes and cutlery are loaded into the dishwasher
the spray arms are free to rotate.
2. Open the tap fully.
3. Close dishwasher door.
4. Turn the programme dial clockwise to A or B (see “Programme Table“).
1 For interference suppression reasons, only operate the programme dial
with the dishwasher switched off. It is also possible that the automated
addition of detergent is triggered.
5. Press the button for the programme required (see „ Programme Table“).
6. Press ON/OFF button. Power indicator light illuminates. The selected
wash programme starts. The programme dial rotates during the wash
programme and indicates the position that has been reached in the
programme.
1 If a wash programme has been started even though the tap was closed,
switch off the dishwasher with the ON/OFF button, open the tap and
start the wash programme again.
Changing/Interrupting the Wash Programme
3 Only change or interrupt a wash programme in progress if it is abso-
lutely necessary.
Changing the wash programme
0 1. Press ON/OFF button. Power indicator light goes out, wash programme
stops.
1 Hot steam may escape when the door is opened. Open the door care-
fully.
2. Open dishwasher door and check whether there is still detergent in the
container. Refill the container if necessary.
3. Close dishwasher door.
4. Turn the programme dial clockwise to A or B (see “Programme Table“).
5. Press the button for the programme required (see “Programme Table“).
6. Press ON/OFF button. ON/OFF button indicator illuminates. The selected
wash programme starts.