Safety switch oﬀ – Silvercrest SIKP 3400 A1 User Manual

Page 75

SKIP 3400 A1

5) To switch the cooking area 1 oﬀ , press the button "On / Standby" w.

To switch all cooking areas 1 2 4 oﬀ at the same time, press the button
"On / Standby" t.

NOTICE

►

When all 3 cooking areas 1 2 4 are oﬀ , after usage or adjustment,
you must ﬁ rst press the button "On / Standby" t to carry out new settings.

NOTICE

►

After switching on or oﬀ , an "- L" or a "- H -." appears in the display.
This heat indicator means:

–

"- L -" = "Low" - Temperature of the cooking areas 1 2 4 < 60°C

–

"- H -" = "High" - Temperature the cooking areas 1 2 4 > 60°C

NOTICE

►

After switching oﬀ , in the standby mode the fans of the appliance continue
to run on for some time, so as to dissipate the heat.

NOTICE

►

The appliance switches itself into the standby mode automatically after
120 minutes.

Safety switch oﬀ

■

For safety reasons, the cookware identiﬁ cation automatically switches the
appliance oﬀ (in standby mode) when you ...

–

remove the cookware from the cooking areas 1 2 4 for longer than
15 seconds, or do not place anything there..

–

Although the energy ﬁ eld is immediately switched oﬀ with short-term
cookware removals - the selected function remains, however, active.
Around every 3 seconds a signal tone issues a reminder that, in roughly
15 seconds, the appliance will switch itself oﬀ automatically. If you
replace the cookware back onto the cooking areas 1 2 4 within
15 seconds, the selected function will continue on the same settings.

NOTICE

►

As soon as you take the cookware from the cooking area, "- - -" blinks in the
display.

IB_75467_SIKP3400A1_LB2.indb Abs2:73

11.07.12 13:28