Silvercrest SDBE 2400 A1 - Manual (Page 47)

45 GB
1. Set the steam flow rate controller|3 to 0
and set the temperature controller|16 to
min.
2. Fill the water tank|15.
3. Connect the mains plug|9 with the wall
socket.
4. Set the temperature controller|16 to the
desired temperature (at least ). The
temperature control lamp|11 lights up.
5. As soon as the ironing temperature has
been reached and the temperature con-
trol lamp|11 goes out, adjust the steam
flow rate controller|3 to the desired
steam flow rate
and start ironing.
The steam will...
… start to come out as soon as you hold
the steam iron horizontal, and
… stop as soon as:
- you hold the steam iron vertically,
- the temperature is too low,
- the water tank is empty
or
- you set the steam flow rate control-
ler|3 to 0.
6. Finish ironing, set the temperature con-
troller|16 to min, set the steam flow
rate controller|3 to 0 and pull out the
mains plug|9.
7. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank|15 through the filling open-
ing in the water tank (under the lid|2).
6.6 Steam burst function
The steam burst function requires a high tem-
perature. Select a temperature setting be-
tween
and max. For this purpose, the
water tank|15 must be at least one quarter
full.
• Press the steam burst button|4
while
the steam iron glides over the item of
laundry.
• Wait a few seconds before you press
the steam burst button|4 again.
NOTE: for smoothing items of clothing that
are hanging up, you can use the steam burst
in a vertical position.
7. Safety shut-off
DANGER! Fire hazard!
Despite the automatic shut-off, the
steam iron must not be left
unsupervised.
Your steam iron possesses a safety shut-off of
the heating function (AUTO SHUT OFF).
Activating the function
The automatic shut-off occurs, if
-
the device has stood still in vertical posi-
tion for approx. 8 minutes.
- the device has stood still on the sole
plate for approx. 30 seconds.
- the device has laid on its side for ap-
prox. 30 seconds.
When the safety shut-off is activated, an
alarm sounds for approx. 3 seconds and the
operating lamp|6 starts to flash until the
function is switched off.
Switching off the function
Pick up the steam iron by its handle|7 and
hold it horizontally for a few seconds or
make some ironing movements.
__CPE100696_B5.book Seite 45 Freitag, 11. Juli 2014 10:44 10