beautypg.com

Safety shut-off – Silvercrest SDBE 2400 A1 User Manual

Page 51

background image

49

GB

1. Set the steam flow rate controller|3 to 0

and set the temperature controller|16 to
min.

2. Fill the water tank|15.
3. Connect the mains plug|9 with the wall

socket.

4. Set the temperature controller|16 to the

desired temperature (at least ). The
temperature control lamp|11 lights up.

5. As soon as the ironing temperature has

been reached and the temperature con-
trol lamp|11 goes out, adjust the steam
flow rate controller|3 to the desired
steam flow rate

and start ironing.

The steam will...
… start to come out as soon as you hold

the steam iron horizontal, and

… stop as soon as:
- you hold the steam iron vertically,
- the temperature is too low,
- the water tank is empty

or

- you set the steam flow rate control-

ler|3 to 0.

6. Finish ironing, set the temperature con-

troller|16 to min, set the steam flow
rate controller|3 to 0 and pull out the
mains plug|9.

7. Allow the steam iron to cool down, and

pour off any remaining water from the
water tank|15 through the filling open-
ing in the water tank (under the lid|2).

6.6 Steam burst function

The steam burst function requires a high tem-
perature. Select a temperature setting be-
tween

and max. For this purpose, the

water tank|15 must be at least one quarter
full.
• Press the steam burst button|4

while

the steam iron glides over the item of
laundry.

• Wait a few seconds before you press

the steam burst button|4

again.

NOTE: for smoothing items of clothing that
are hanging up, you can use the steam burst
in a vertical position.

7. Safety shut-off

DANGER! Fire hazard!
Despite the automatic shut-off, the
steam iron must not be left
unsupervised.

Your steam iron possesses a safety shut-off of
the heating function (AUTO SHUT OFF).

Activating the function

The automatic shut-off occurs, if
-

the device has stood still in vertical posi-
tion for approx. 8 minutes.

-

the device has stood still on the sole
plate for approx. 30 seconds.

-

the device has laid on its side for ap-
prox. 30 seconds.

When the safety shut-off is activated, an
alarm sounds for approx. 3 seconds and the
operating lamp|6 starts to flash until the
function is switched off.

Switching off the function

Pick up the steam iron by its handle|7 and
hold it horizontally for a few seconds or
make some ironing movements.

_CPE100696_Dampfbügeleisen_B1.book Seite 49 Freitag, 11. Juli 2014 10:30 10