Silvercrest RFH 2401 - Manual (Page 16)

SilverCrest RFH 2401
14 English
Powering the Headphones On/Off
If the battery level of the headphones is high enough (the power and
charge indicator (18) on the transmitter must be green), you may remove
the headphones from the transmitter cradle.
You may optionally power the headphones using conventional batteries.
For more information, see the information on page 18 – Battery Operation.
1. Press the On/Off button (10) of the headphones once to switch them on.
The power indicator (8) will light up orange.
2. Press the On/Off button of the headphones again to switch them off.
The power indicator then goes out.
Please remember to set the correct position for the Power
source DC1/DC2 selection switch (9). When set at DC2
position, the device will power on only if charged batteries
have been inserted into the headphones. Please also see
page 18 - Powering the Headphones by Using Batteries.
Selecting the Operating Mode
1. Slide the mode selection switch (4) to the “WL” position to use the
wireless headphones to listen to an external audio source (e.g. your hi-fi
equipment).
2. Slide the mode selection switch (4) to the “FM” position to receive your
favourite FM radio programmes.
Powering the Transmitter Cradle On
1. To power the transmitter cradle on, slide the On/Off switch to the “ON”
position.
After powering on, the send indicator (17) lights up orange. This
indicates that the transmitter cradle is attempting to establish a
connection with the headphones. See also the description on page 15 –
Synchronising the Headphones and Transmitter Cradle.
Synchronising the transmitter cradle and the headphones
can take a while.