beautypg.com

Solutions to common problems, Common washing problems, continued – Electrolux 137519000 A (1112) User Manual

Page 24

background image

24

Solutions to Common Problems

Common Washing Problems, continued

PROBLEM

POSSIBLE CAUSES

SOLUTIONS

PREVENTIVE MEASURES

Yellow
buildup of
body soil
on synthetic
fabrics

• Agitation time too short.
• Wash water temperature too

low.

• Not enough detergent.

• Soak in detergent booster or

product containing enzymes.

• Wash in hottest water safe for

fabric using casual cycle.

• Increase detergent.
• Add bleach safe for fabric or

treat with color remover.

• Select correct wash cycle.
• Use correct amount of

detergent.

• Wash synthetics frequently

using hot or warm water.

Yellow or
brown rust
stains

• Iron or manganese in water

supply, water pipes, or wa-
ter heater.

• To restore discolored load of

whites, use rust remover safe for
fabric.

• Do not use chlorine bleach to re-

move rust stains. It may intensify
discoloration.

• Use nonprecipitating water

softener.

• Before washing, run hot water

for a few minutes to clear lines.

• Drain water heater occasionally.
• For an ongoing problem,

install an iron fi lter in your
water supply system.

Residue
stains / build-
up, mold or
mildew stains
in gasket

• Moisture in the washer.
• Use of non-HE detergent.
• Overdosing detergent.
• Overloading wash drum.
• Leaving a wet load set in

washer.

• Cold water washes which

may not completely dissolve
and remove detergents.

• Perform CLEAN WASHER cycle
• Scrub gasket with Comet™

Spray Gel Mildew Stain Remover
using brush to remove stains.

• Use only HE (high effi ciency

detergent) along with recom-
mended dosage.

• Remove wash load immediately

upon cycle completion.

• Run dehumidifi er in laundry

room.

• Avoid overfi lling detergent

and fabric softener com-
partments of dispenser.

• Dry the inside of washer

and gasket after every run.

Residue
stains / build-
up, mold or
mildew stains
in dispenser
drawer

• Moisture in the washer.
• Use of non-HE detergent.
• Overdosing detergent.

• Remove dispenser drawer and

wipe dispenser and inserts with
combination of ¾ cup liquid
chlorine bleach and one gallon
hot water. Rinse well, and repeat
if necessary. Return drawer to
location. NOTE: Wear rubber of
latex gloves. Protect fl oor and
clothing from bleach damage.

• Use only HE (high effi ciency

detergent) along with recom-
mended dosage.

• Avoid overfi lling detergent

and fabric softener com-
partments of dispenser.

Water in fold
of fl exible
gasket

• Result of washing and part

of normal operation.

• At the end of each wash, dry

inside of gasket fold with clean
dry towel all around gasket.

Odor

• Moisture in the washer.
• Use of non-HE detergent.
• Overdosing detergent.
• Leaving a wet load remain in

washer.

• Cold water washes which

may not completely dissolve
and remove detergents.

• Perform CLEAN WASHER cycle.
• At the end of each wash, dry

inside of gasket fold with clean,
dry towel all around gasket.

• Use only HE (high effi ciency

detergent) along with recom-
mended dosage.

• Remove wash load immediately

upon cycle completion.

• Pour one cup liquid chlorine

bleach in standpipe; let remain a
day and fl ush with water.

• Leave door and dispenser

drawer open for a few
hours after use or whenever
washer is not in use.