Silvercrest 4-LD3905 - Manual (Page 3)

- 3 -
nail or screw on a flat wall. The alarm clock is not intended for use
in rooms with high humidity (example: bath room).
Make sure that:
• the device isn’t placed on a thick carpet or bed during
operation ;
• no direct heat sources (i.e. radiators) influence the device;
• no direct sunlight reaches the device;
• contact with splashing or dripping water must be avoided
(don’t place any items filled with liquids, i.e. vases, onto or
next to the device);
• the device doesn’t stand near magnetic fields (i.e. speakers);
• candles and other open flames must be kept away from this
product at all times to prevent the spread of fire
• no foreign objects penetrate the housing.
User
This device may be used by persons (including children over 8
years of age) with reduced physical, sensory or mental abilities or
lack of experience and knowledge, if they are supervised or
instructed regarding the safe use of the device and understand the
dangers that may arise. Children may not play with the device.
Cleaning and user maintenance of the device may not be
performed by children without supervision. Keep packaging films
out of the hands of children. There is a danger of suffocation.
Batteries
Keep batteries out of reach of small children. If a battery is
swallowed, you must seek medical attention immediately.
Batteries/rechargeable batteries must always be inserted in the
correct polarity. If necessary, clean the battery and device
contacts. Never attempt to recharge non-rechargeable batteries.
Never short-circuit or attempt to open batteries. Never throw
batteries into fire as they may explode.
If the device will not be used for an extended time period, remove
the battery and store the device in a dry and dust-free area.
Improper use of the battery can lead to explosion or leakage.
If the battery leaks, avoid contact with skin, eyes and mucous
membranes. Use gloves. If you are exposed to battery acid, rinse
the affected areas with plenty of clean water and immediately
seek medical attention. Remove discharged batteries from the
device as they present an increased risk of leakage.
- 4 -
Features
•
Analogue radio controlled time
•
LC display with temperature, date and alarm indicator
•
Light
•
Snooze
1 SNOOZE/LIGHT 5 SET
2 ALARM setting button 6
Battery compartment
with cover
3 RESET 7 ALARM on/off switch
4 REC
Setup
Open the battery compartment on the backside of the device and
insert one 1.5V AA R6/LR6 battery in the correct polarity. Close
the battery compartment.
The hands of the alarm clock will now move to the 12:00:00,
4:00:00 or 8:00:00 o'clock position and stop. The alarm clock
will now begin to receive the DCF 77 radio time signal. This
process will take around 3 to 10 minutes.
Note: Please do not move the alarm clock during the reception
process.
If the radio time reception attempt is successful, the hands will
automatically move to the correct position and the correct date
will be set. If the reception attempt fails, the clock will restart the
reception attempt hourly and the hands will stay in the reception