Silvercrest SOR 2600 A1 - Manual (Page 23)

- 21 -
• Do not place open fire sources, e.g. candles,
on the appliance.
Warning: To avoid an overheating of the
oil radiator it may not be covered!
• Clean the appliance at regular intervals.
• Do not use an external timing switch or a separate
remote control system to operate the appliance.
• Do not position the appliance underneath a
mains power socket.
Injury hazard
• Lay the power cable in such a way that no one
can tread on or trip over it.
• Do not use extension cables. In an emergency
the power plug must be quickly accessible.
Items supplied
Oil Radiator
2 Roller rails
2 Mounting bracket
4 Wing nuts
Operating instructions
Technical data
Rated voltage: 220 240 V ~ 50 Hz
Heat output: 2300 2600 W
Heat level: I = 800 W
II = 1200 W
III = 2000 W
Thermostat: Infinitely variable
Heating gills: 9
Description of the appliance
1 Control lamp “Power”
2 Heat level switch
3 Thermostat
4 Warm air switch with integrated
warm air control lamp
5 Warm air outlet
6 Cold air intake
7 Power cable retainer
8 Mounting bracket
9 Roller rails
0 Wing nuts
Assembly
Use the fold out page of these instructions to assist
you with the assembly.
1. Take the oil radiator and all components from
the package and remove all packaging materials.
2. Place the oil radiator, with the base uppermost,
on a soft surface, for example a carpet.
3. Place a mounting bracket 8 under the heater
element so that the parts with a screw thread
project upwards.
4. Lay a roller railer 9 over it, such that the screw
threads protrude through the holes. Check to
ensure that the recesses on the roller railers 9
face outwards. The screw ends projecting from
the appliance must reach into the recesses.
5. Screw one wing nut 0 onto each of the threaded
ends of the mounting bracket 8 until it is hand
tight.
6. Proceed in the same manner with the other side.
7. Turn the appliance over and place it on the rollers.