Silvercrest SWW 1500 B2 - Manual (Page 52)

50
If one or both switches are switched to
"ON", the red indicators will illuminate in the
corresponding switches and the appliance
will heat up according to the corresponding
heating setting.
If both switches are set to "OFF", the appli-
ance will not produce any heat.
6.3 Selecting the temperature
Set the required temperature with the
temperature selector 6.
• When the required room temperature is
reached, slowly turn down the
temperature selector 6 until you hear a
quiet "click".
The red indicators in the switches 4 and
5 will be extinguished.
The current room temperature will be
maintained.
As soon as the appliance needs to heat
up again to maintain the temperature,
the red indicators in the switches 4 and
5 will light up once again in the
meantime.
6.4 Thermal cut-out
For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, it will turn itself off automati-
cally:
1. To turn the heating off, set the
temperature selector 6 to "MIN".
2. Remove the mains plug.
3. Allow the appliance to cool down.
4. Make sure that the air can circulate
freely.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or do not use it.
5. You can continue to operate it normally
after repair.
6.5 Safety switch
The appliance is protected against
accidental damage by a safety switch.
Should this occur, the safety switch will turn
the appliance off immediately:
• Return the appliance to an upright
position. The appliance will switch on
again automatically.
6.6 Transporting the appliance
If you wish to transport the appliance,
always carry it using the carry handle 3.
CPE100696 Wärmewelle LB5 Seite 50 Donnerstag, 26. Juni 2014 4:54 16