Silvercrest SWW 1500 B2 - Manual (Page 53)

SWW 1500 B2 51
7. Cleaning
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits
with a vacuum cleaner.
2. Clean the outside of the appliance with
a damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
3. Wipe the appliance with a cloth
moistened with clear water.
4. Do not use the appliance again until it
has dried completely.
8. Troubleshooting
Fault Cause Remedy
Appliance cannot be
switched on Faulty fuse or wall socket Select another wall socket
Faulty appliance Have repairs carried out at a specialist
workshop or dispose of the appliance.
You will find the service address in
“Service Centre” on page 53.
Appliance switches
off automatically Thermal cut-out has
triggered Allow the appliance to cool down (see
“6.4 Thermal cut-out” on page 50)
Clean the appliance (see
“7. Cleaning” on page 51)
Appliance does not
heat Selected temperature has
been reached Heating switches on again automati-
cally as soon as the room temperature
falls
Select a higher required temperature
CPE100696 Wärmewelle LB1 Seite 51 Donnerstag, 26. Juni 2014 4:51 16