Silvercrest Z30170 - Manual (Page 35)

37 GB/MT
Operation
Press the Digital timer / UNIT / Alarm / -
button
4 to start the alarm function. The
Alarm symbol 18 appears in the display.
You can switch off the alarm function by
pressing the Digital timer / UNIT / Alarm / -
button
4 again. The Alarm symbol 18
disappears from the display.
When the set alarm time is reached, an
audible alarm signal sounds for about one
minute.
No audible alarm signal sounds if the set
time is reached when the device is in the
weighing mode. Instead the Alarm symbol
18
flashes in the display.
Note: If no button is pressed within a period
of two minutes, the kitchen scale’s display
automatically shows the time.
Using the digital timer
Press the MODE / + button 5 until the
device enters the digital timer mode. This
comes after the alarm function.
Press the SET / WEIGHT MODE button 3
to enter the settings mode. The seconds
display value flashes.
You can use the MODE / + button 5 or the
Digital timer / UNIT / Alarm / - button 4 to
set the value.
Press the SET / WEIGHT MODE button 3
to store the set value and move on to setting
the minute display value. The minute display
value flashes.
You can use the MODE / + button 5 or the
Digital timer / UNIT / Alarm / - button 4 to
set the value.
Press the SET / WEIGHT MODE button 3
to store the set value and leave the settings
mode.
Press the Digital timer / UNIT / Alarm /
- button
4 to start the digital timer. The digital
timer indicator 21 appears in the display.
Note: While the digital timer continues to
run, you can switch the device to another
function by pressing the MODE / + button
5 .
The digital timer indicator 21 then continues
to appear in the display.
You can switch off the digital timer by press-
ing the Digital timer / UNIT / Alarm /
- button
4 again. The digital timer indicator
21 disappears from the display.
When the set time expires, an audible alarm
signal sounds for about one minute and the
previously set time appears on the display.
No audible alarm signal sounds if the set
time is reached when the device is in the
weighing mode. Instead the digital timer
indicator
21 flashes in the display.
Note: If no button is pressed within a period
of two minutes, the kitchen scale’s display
automatically shows the time.
Resetting the settings
The reset button 11 can be found on the
back of the housing. Press this button to reset
all the settings to the default factory settings.
Replacing the batteries
When the batteries become weaker, the
battery charge state indicator
19 in the
display will light up.
Replace the batteries as soon as the symbol
“
” appears in the display. Weak or ex-
hausted batteries can affect the accuracy of
the measurement results.
Open the battery compartment 8 on the
back of the scale.
Remove the discharged batteries and dispose
of them properly in accordance with the ap-
plicable regulations (see section “Disposal”).
Insert two new batteries type CR2032,
3 V
into the battery compartment 8 .
Make sure you fit the batteries the right way
round (polarity). The correct polarity is
shown under the battery compartment
8 .
Then close the battery compartment 8 .
63925_silv_Digitale_Küchenwaage_content_LB5.indd 37 21.02.11 17:13