Silvercrest SWED 100 A1 - Manual (Page 9)

- 7 -
Setup
• Unfold the telescopic aerial and draw it out to its full length.
• Push out the support if you wish to position the appliance at an angle.
Then turn the telescopic aerial to a slanted upward angle.
Receive Mode
a) Switch appliance on/off
• To switch the device on, press the button "POWER ON"
.
• The green POWER LED glows for as long as the device is switched on.
• To switch the device off, press the button "POWER OFF" .
b) Adjusting the reception
• If you have switched the device on by pressing the button "POWER ON"
,
first select the reception range FM, AM or SW 1-7. For this, slide the wave-
band selector switch
into the appropriate position.
• Then search for the desired radio station by slowly turning the tuning
regulator “TUNING” until you have clear reception. In the display
the frequency just received is shown digitally, together with the unit
“MHz” (Megahertz) or “kHz” (Kilohertz).
c) Adjust sound volume
• Set the desired volume level using the volume regulator “VOL”
.
d) Switching the display illumination on
• Hold the button “LIGHT”
pressed down to switch on the display
illumination.
IB_61893_SWED100A1_LB3.qxd 24.02.2011 10:59 Uhr Seite 7