Silvercrest SMZ 260 G1 - Manual (Page 32)

- 29 -
Chopping
Note
Before using the appliance for the first time, clean it
thoroughly as per the instructions given in the chapter
"Cleaning".
➩
Place the bowl 6 in the appliance base 9.
➩
Place the blade holder 5 with the knife 7 on
the mounting 8.
➩
Prepare the items to be processed by cutting large
pieces to a size that will fit in the bowl 6.
➩
Place the food to be processed in the bowl 6.
Thereby, take note of the following table:
Foodstuff
Filling
quantity
Processing
time
Speed
Salami 130 g 3 x 5 secs. Turbo
Cheese
(Gouda,
young,
refrigerator
temperature)
100 g 4 x 15 secs. Turbo
Onions
Garlic
100 g pulsating Turbo
Carrots 100 g 3 x 5 secs. Normal
Dried fruit 130 g 4 x 15 secs. Turbo
Almonds 50 g
coarse:
1 x 10 secs.
middle:
2 x 10 secs.
fine:
3 x 10 secs.
Turbo
Eggs
(hard boiled)
150 g 2 x 4 secs. Turbo
Walnuts 50 g 2 x 8 secs. Turbo
Ice cubes 100 g pulsating Turbo
➩
Close the bowl 6 with the lid 4: Place it on the
bowl 6 so that the lugs on the lid 4 engage in
the slots on the bowl 6. Then turn the lid 4 so
that the lugs slide under the slots and the lid 4
locks into place.
➩
Place the motor block 2 on the lid collar 3.
➩
Press the motor block 2 downwards, as shown
in Figure B. The motor starts with the normal
operating speed.
➩
To make use of the higher processing speed
"Turbo", press, in addition to the motor block 2,
the turbo button 1 and keep it pressed down,
as shown in Figure C.
Note
Should larger pieces of the contents collect on the
wall of the bowl while processing, lift the motor
block 2 from the lid collar 3. Shake the bowl 6
vigorously and then continue with the processing.
Before the processing, particularly hard foods must
be cut into smaller pieces (about 2cm). Otherwise,
the motor could block. With hard foodstuffs select a
pulsating processing. For this, press the turbo button
1 repeatedly for a short time (in addition to the
motor block 2). Should the foodstuff not be com-
pletely pulverised, you can either cut it into smaller
pieces or lift the motor block 2 from the lid col-
lar 3. Shake the bowl 6 vigorously and then con-
tinue with the processing.
➩
When the contents have been sufficiently chopped,
release the motor block 2 and, if necessary, the
turbo button 1.
➩
Unplug the power cable from the socket.