Setting the time (fig. a), Operation weighing (fig. a), Incremental weighing (fig. a) – Silvercrest 100926-14-01/100926-14-03/Z31622B User Manual
Page 45: Troubleshooting
45
GB/MT
Setting the time (Fig. A)
After you have inserted the batteries, the scale switches auto-
matically into the time mode
5
. As soon as the scale has
switched into the time mode
5
, the hour value flashes in the
LC display
1
. In this event, skip the next two steps.
If the scale is in the weighing mode, press and keep pressed
the MODE button
3
for approx. 2 seconds to switch into
the time mode
5
.
Press and keep pressed the TARE button
2
for approx.
3 seconds to set the time.
Press the MODE button
3
to set the desired hour value.
Press and keep pressed the MODE button
3
to speed up
the value-setting process.
Press the TARE button
2
to confirm your setting. Then the
minute value flashes.
Press the MODE button
3
to set the desired minute value.
Press and keep pressed the MODE button
3
to speed up
the value-setting process.
Press the TARE button
2
to confirm your setting.
Note: If you do not press another button within 60 seconds,
the set value stops to flash and the time is set.
Operation
Weighing (Fig. A)
If the scale is in the time mode
5
, press the MODE button
3
once to switch into the weighing mode.
Note: Shortly before the scale switches into the weighing
mode, the scale shows “HELO” in the display for 1–2 sec-
onds.
1. Place the kitchen scale on a solid, flat surface.
2. Press the MODE button
3
once to change the weight unit
indicator (g / ml / lb’oz / fl’oz).
3. Place the substance to be weighed on the scale. The
weight of the substance being weighed is shown in the
LC display
1
.
Incremental weighing (Fig. A)
1. Follow steps 1 to 3 of the section on “Weighing” and
press the TARE button
2
. The LC display
1
shows 0
and the TARE symbol
10
appears.
2. Add another substance to be weighed to the scale. The
LC display
1
shows the weight of the newly added sub-
stance.
3. If you remove the added substance from the scale, the
LC display
1
shows 0.
4. If you remove all of the substances to be weighed from
the scale, the LC display shows a negative value
11
.
5. Press the TARE button
2
once and the TARE symbol
10
ceases to be displayed.
If there is no substance to be weighed on the scale and if 60
seconds elapses without a button being pressed or no movement
on the scale plate is noted, the scale switches automatically
into the time mode
5
.
Troubleshooting
=
Fault
= Cause
= Solution
100926_silv_Digitale Kuechenwaage_Content_ES_IT_PT.indd 45
03.06.14 12:07