Livarno Z29549 User Manual
Page 2
4
GB
Safety advice / Assembly / Cleaning and Care / Disposal
50 kg
Do not load more than 50 kg onto the product. Otherwise
there is a risk of injury and/or damage to the product.
DANGER OF ELECTRIC SHOCK! DANGER OF DAM-
AGE TO PROPERTY! DANGER OF INJURY!
Ensure that
you do not strike electrical cables, gas or water pipes when you
are drilling into the wall. If necessary, check the wall using a suitable
detector before you drill.
Check that the product is stable before using it.
Do not lift the product and do not move it when it is loaded.
To avoid damaging your property
Check before fastening the product to the wall whether the wall is suitable
for the product to be fastened to it. If necessary, seek the advice of a
suitable specialist.
Examine the wall before installation and choose suitable installation
fixings. We have supplied fixings suitable for an ordinary solid masonry
wall.
First load the lowest drawer and then work your way up to the top drawer.
Always store heavier articles in the lowest drawers.
Assembly
Note:
Assemble the product on a scratch-resistant floor that is sufficiently
large. You may have to put a blanket or the like down in order to avoid
damaging the product.
Note:
To assemble the product, you will need a drill with a drill bit 8 mm in
diameter and a Phillips screwdriver.
Note:
This product requires wall mounting. Make sure that you position the
mounting material at the right height. Otherwise you will not be able to mount
the product correctly.
Assemble the product in accordance with Figs. A to F.
Figure G (wall mounting):
Measure the height of the holes in the top panel
1
after the product
has been completely assembled (Figs. A - F).
Using a pencil or similar instrument, mark the positions of the drilled
holes on the wall.
WARNING!
RISK OF FATAL INJURY!
Please ensure that you
do not drill into any electrical wiring, gas or water pipes in the wall. If
necessary, carry out checks with a wire, pipe and stud detector before
you drill into a wall.
CAUTION! DANGER OF INJURY! Refer to the operating instructions
for your electric drill.
Drill the holes with a size 8 mm drill bit and insert the dowels
27
into the
drilled holes.
Screw the screw hooks
26
into the dowels
27
. Make sure that the hooks
point upwards at the end of this process.
There are two predrilled holes on the underside of the top
1
.
Use these holes to hook the cabinet on to the screw hooks
26
.
Note:
Regularly check the stability of all connections and retighten the
screws.
Cleaning and Care
Use a slightly dampened, non-fluffing cloth to clean the product.
Do not under any circumstances use corrosive or abrasive cleaning
agents. These may damage the product.
Disposal
The packaging is made entirely of recyclable materials, which you
may dispose of at local recycling facilities.
Contact your local refuse disposal authority for more details of how to dispose
of your worn-out product.
Product description:
Cabinet
Model No.:
Z29549
Version: 01 / 2011
61417_liv_Kommode_Content_LB4.indd 4
03.01.11 11:24