Echo PE-265 - Manual (Page 9)

P
OWER
E
DGER
O
PERATOR
'
S
M
ANUAL
9
A
SSEMBLY
Tools Required: 4 mm Hex Wrench, 8 x 10 mm Open-end Wrench
Parts Required: Power head, Drive Shaft Assembly
DRIVE SHAFT
/
POWER HEAD
1. Stand power head upright on a level surface.
2. Loosen the two (2) drive shaft clamp bolts (B) at engine drive shaft
clamp, and remove center drive shaft location bolt (A).
3. Remove dust cap and carefully fit drive shaft assembly to engine
making sure that inner drive shaft engages into clutch mount.
4. Turn drive shaft housing until locating hole lines up with location
hole in clamp and install center drive shaft location bolt (A).
NOTE
Gear Housing must be aligned properly with engine. Aligning
center locating hole in driveshaft housing with center drive shaft
bolt (A) provides correct alignment.
C
ONTENTS
The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions,
some assembly may be necessary.
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing
parts. Use the contents list to check for missing parts.
__ 1, Power Head
__ 1, Drive Shaft Assembly
__ 1, Plastic Bag (Co-Pack)
__ 1,
Operator's Manual
__ 1, Safety Manual
__ 1, Warranty Registration Card
__ 1, ECHO Emissions and Warranty Statement
__ 1, Echo Power Blend X TM 2-stroke oil sample
__ 1, Front Handle
__ 1, Lower Bracket, Front Handle
__ 4, 5 x 35 mm screws
__ 4, 5 mm nuts*
__ 1, T-Wrench
__ 2, Split pin
__ 1, 4 mm Hexagon Wrench
__ 1, Locking Tool
__ 1, 8 x 10 mm Spanner Wrench
__ 1, Safety Glasses
* 5mm nuts may not be needed.
A
B
B