Eureka 950 Serias - Manual (Page 14)

ENGLISH
Caution: Risk of injury. Do not use Dust Container
Handle to carry cleaner.
INSTRUCTIONS FOR USE
• Do not operate without the filters in place.
1 Pull power supply cord out from back of cleaner and plug into electri-
cal outlet. To rewind, remove from electrical outlet, step on cord reel
button, hold and guide plug while it rewinds.
Note: When pulling on power supply cord watch for a yellow line on
the cord. Then continue slowly pulling on cord till you see the red
line, stop. The red line indicates the end of usable cord.
2 Press the ON/OFF button to switch the cleaner on. (I) is ON/ (O) is
OFF.
3 To rewind the power cord, press the rewind button with foot and
guide the cord with hand to ensure that it does not whip causing
damage.
4 By moving the suction control button, the suction power can be
adjusted.
5 Suction can also be regulated on the hose handle by opening / clos-
ing the button.
HOW TO USE
Floors should be cleaned regularly over heavily traveled areas, and once
a week over the entire area. Vacuum slowly, making several passes (for-
ward and backward), covering small areas at a time. The time required to
clean will depend on several factors - including type of floor and amount
of dirt.
Cleaning Tools
5 Hose Handle: On/Off ( I )/(o) switch is to turn the Power Nozzle
brushroll on and off. On ( I ) for carpets and Off (o) for hard sur-
faces.
6 Crevice Nozzle*: (stored on tool clip on wand): For crevices,
corners, baseboards, between cushions.
7 Upholstery Nozzle*: (stored on tool clip on wand): For curtains,
draperies, cushions, fabrics.
8 Turbo Brush*: For upholstery and for stairs.
9 Bare Floor Brush*: For any type of hard surface floor.
10 Combo Brush*: For furniture, blinds, books, lamp shades, shelves
11 Handle-to-tool Adapter*: Place on end of hose to allow cleaning
tools to fit. Not required at end of wand.
12 Tool Caddy*: To store cleaning tools. Clips on wand.
*(on some models)
1.
2.
3.
4 .
6*
10*
8*
9*
12*
11*
5
7*
Hose
Suction
Control
Button
!
14