beautypg.com

Fig.2, Maintenance, Operation fig.4 – Sealey MS850PS User Manual

Page 3: Fig.5

background image

Fig.2

Fig.3

LOCKING

BUTTON

WARNING! Ensure you read, understand and apply the safety instructions in Section 1.

Ensure the power control switch is NOT locked on before plugging into the mains.

5.1.

Hold the polisher firmly with one hand on the handle grip and the other on the side handle. To

select the required speed rotate the speed selector switch (fig.4.2) to the required speed 1 to 6.

5.1.1. To start the polisher press and hold down the safety lock button (fig.4.1) and squeeze the trigger.

When releasing the trigger, the safety lock button will engage, preventing the polisher from being

inadvertently started.

WARNING! The high speed settings are intended for sanding. If used for polishing an excessive

amount of surface material may be removed.

Note: As the rubber support disc is flexible, when sanding it should not be used head on, but at an

angle of approximately 10 to 20 degrees.

Contact your Sealey Dealer for details of compound heads and lambs wool bonnets.

6. MAINTENANCE

WARNING! Before attempting any maintenance ensure the unit is unplugged from

the mains power supply.

6.1.

Keep the machine clean and dry. Do not use abrasives to clean the unit. Ensure all

external head screws are tight.

6.2.

Clean regularly by blowing a jet of compressed air through side vents to ensure motor

ventilation is kept clear.

WARNING! Wear approved safety eye protection and, if necessary, respiratory

protection.

NOTE: The following maintenance must only be carried out by a technically qualified

person or an authorised Sealey service agent.

6.3.

Check carbon brushes by removing each side screw (fig.5). Check to see if the brushes

are worn or cracked. If so, the brushes must be replaced to avoid sparking and damage

to the armature. Always change brushes as a pair. Use only genuine spare parts as

these are specifically designed for the machine. Failure to do so may be dangerous and

will invalidate your warranty.

6.4.

After each 500 hours of use replace the gear head grease to prevent gear wear and

possible drive failure.

5. OpERATION

Fig.4

1

2

Fig.5

WARNING! The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations

that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must

be applied by the operator.

noTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.

IMpORTANT: No liability is accepted for incorrect use of this product.

WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.

INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.

01284 757500

01284 703534

[email protected]

Sole UK Distributor, Sealey Group,

Kempson Way, Suffolk Business Park

,

Bury St. Edmunds, Suffolk,

IP32 7AR

www.sealey.co.uk

Web

email

Original Language Version

MS850PS Issue: 2 - 19/02/10