Operation, Maintenance – Sealey ER1700P User Manual
Page 3
WARNING! Before attempting any maintenance ensure the unit is unplugged from the mains power supply.
6.1.
Keep the machine clean and dry.
DO NOT use abrasives to clean the unit. ensure all external head screws are tight.
6.2.
clean regularly by blowing a jet of compressed air through side vents to ensure motor ventilation is kept clear.
WARNING! Wear approved safety eye protection and, if necessary, respiratory protection.
WARNING! Before use, ensure that you have read and understood Section 1 Safety.
6.1. Attach the backing pad. (see section 5.2.2.)
6.2. Plug the polisher into the mains power supply.
6.3. With the polisher firmly held by the side handle and away from the workpiece, turn the polisher on by squeezing the trigger (fig.4).
Pressing in the "run" button (fig.3 and fig.4) will hold the trigger and allow for continuous running. Finally release the trigger.
6.4. to stop the polisher, squeeze the trigger, the "run" button will spring out and the polisher will stop.
6.5. the speed of the polisher can be adjusted using the variable speed dial recessed in the top face (fig.3). slide the dial forward to
increase the speed or backward to reduce the speed (fig.3).
6.6. check that the unit is working correctly before use.
6. OPERATION
spindle lock button
fig.2
continuous run
button
fig.3
recessed speed dial
Fast
slow
continuous run button
trigger
fig.4
6. MAINTENANCE
er1700P.V3 Issue: 1 - 02/04/15
Original Language Version
© Jack sealey limited
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park
,
Bury st. edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
WEEE Regulations
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.