Sealey CP6018V - Manual (Page 2)

2. INTRODUCTION & SPECIFICATIONS
Professional heavy-duty hammer drill has been ergonomically
designed for less operator fatigue and ease of control. With 18
different torque settings, this allows the drill to penetrate a number of
different applications. Built in LED light enables work to be carried
out in dark areas. 13mm Single sleeve chuck with spindle locks
allows for quick and easy bit change. Supplied with two Lithium-ion
batteries which allow for longer operation and a one hour charge
time.
Model no: .............................................................................. CP6018V
Battery type: ...............................................................Li-ion 18V 1.5Ah
no load speed (low speed setting): ....................................... 0-350rpm
no load speed (high speed setting): ................................... 0-1400rpm
Impact Rate (low speed setting):........................................ 0-4550bpm
Impact Rate (high speed setting: ..................................... 0-18200bpm
noise Power: ........................................................................... 96.58dB
noise Pressure ........................................................................ 85.58dB
Vibration Emission ................................................................ 14.22m/s²
Maximum torque: .........................................................................50nm
Replacement battery: ....................................................... CP6018VBP
Chuck size: ...............................................................................Ø13mm
Weight (including battery): ............................................................2.4kg
Drilling Capacities (guide):-
Wood: .......................................................................................Ø32mm
Steel:.........................................................................................Ø13mm
Concrete: ..................................................................................Ø13mm
1.3 BATTERY SAFETY INSTRUCTIONS.

WARNING! Battery contains lithium-ion which is dangerous.
Handle with care to avoid damage, fire, corrosion or personal
injury.

Charge battery prior to its first use. the battery will have
been shipped in a low charge state.
To reduce the risk of burns or fire:
 DO NOT Attempt to open, disassemble, modify or service the
battery pack.
 DO NOT Crush, puncture, short external contacts or dispose of
in fire or water.
 DO NOT Expose to temperatures above 40°C (104°).
 Replace only with the battery pack designated for this product.
 Recycle or dispose of used battery as stipulated by local
regulation.

Use only the charging base provided to charge the drill
battery.

DO NOT attempt recharging the battery by means of an engine
generator or a DC power source.
 WARNING! Dispose of spent batteries correctly as they contain
Lithium-ion. DANGER! DO NOT attempt to disassemble the
battery. For safety and environmental reasons DO NOT discard
in domestic waste or by burning. ONLY discard or recycle
according to local authority regulations.
 WARNING! DO NOT allow a leaking battery to contact your
person. If you come into contact with battery liquid take the
following immediate action:
 a) Skin contact: Wash immediately with soap and water,
then wash flesh in either lemon juice or vinegar.
 b) Eye contact: Wash with a strong solution of boric acid,
and seek immediate medical attention.
Original Language Version
CP6018V Issue: 1 - 15/02/13
Press down spring loaded
catch and slide out battery
in direction indicated.
Fig. 6
- +
1
Battery "health" check
switch and LED's
4
3
5
2
Dimples align with
grooves in drill neck
Rotate handle anti-clockwise to fit
drill neck, rotate handle clockwise to
clamp
Depth gauge thumb screw clamp
8
Screwdriver bit holder
Drill/screw and Hammer icons
6
7
Handle
LED (torch)
Battery location
Green LED
Red
LED
Slide off direction.
(replace opposite)
Fig. 7
"RELEASE/GRIP"
Direction instruction.
© Jack Sealey Limited 2013
Fig. 1
Fig. 2
Fig. 3
Fig. 4 Fig. 5