Sealey E541 - Manual (Page 2)

Supply:.......................................................................................... 230V
Speed: .................................................................................... 7200rpm
Motor Power: ................................................................................. 13W
Noise Power: ........................................................................... 76dB(A)
Noise Pressure: ....................................................................... 65dB(A)
Accessories: ....................................................... Engraving head (1pc)
.............................................................................Letter Template (1pc)
.........................................................................Number Template (1pc)
2. SPECIFICATION
3. OPERATION
3.1. Fitting/Changing Engraving Head
3.1.1. Ensure the tool is switched off and unplugged from the mains supply.
3.1.2. Unscew the grub screw in the spindle (fig.1D).
3.1.3. Remove the engraving head (fig.1C) and replace with a new one.
3.2. Operation
3.2.1. Check that the ON/OFF switch (fig.1A) is set to OFF and then connect the tool to the mains supply. Switch the tool ON
3.2.2. Select the stroke required on the rotary control (fig.1B). Its recommend to use a test piece to find the correct stroke suitable for the
workpiece.
NOTE: DO NOT switch ON with the engraving head touching the workpiece.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
4. MAINTENANCE
4.1. Cleaning
4.1.1. Keep the tool ventilation slots clean and free from obstructions. If available blow compressed air into the vents to clear any internal
dust (safety goggles must be worn when undertaking this process).
4.1.2. Keep the outer case of the tool clean and free from grease.
4.1.3. Wipe down with a damp cloth.
DO NOT wash with water or use solvents or abrasives.
4.2. Servicing
To service the tool contact your local Sealey service agent.
fig.1
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
WEEE Regulations
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
E541 Issue: 2(SP) - 21/03/14
Original Language Version © Jack Sealey Limited