Epson DW076 - Manual (Page 9)

English
7
CAUTION: Never attempt to open the battery pack for any rea-
son. If the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.
LASER OPERATION
• Ensure that the battery is properly charged. If the “Power” LED
light is flashing, the battery needs to be charged.
• To extend battery life per charge, turn the laser off when it is not
in use.
• To ensure the accuracy of your work, check the laser calibration
often. See the Field Calibration Check section of this manual.
• Before attempting to use the laser, make sure the tool is posi-
tioned on a relatively smooth,secure surface.
• Always mark the center of the laser line or dot. If you mark dif-
ferent parts of the beam at different times you will introduce
error into your measurements.
• To increase working distance and accuracy, set up the laser in
the middle of your working area.
• When attaching to a tripod or wall, mount the laser securely.
• When working indoors, a slow rotary head speed will produce
a visibly brighter line, a faster rotary head speed will produce a
visibly solid line.
• To increase beam visibility, wear a Laser Enhancement
Glasses (not included) and/or use a Laser Target Card (not
included) to help find the beam.
• Extreme temperature changes can cause movement or shifting
of building structures, metal tripods, equipment, etc., which can
effect accuracy. Check your accuracy often while working.
• If the laser is dropped or has suffers a sharp blow, have the
calibration system checked by a qualified service center before
using the laser.
NOTE: The DW076 rotary laser has no remote control capability.
Installing and Removing the
Battery Pack
NOTE: Make sure your battery pack is fully
charged before you install it.
INSTALLING THE BATTERY PACK
1. Rotate the battery adapter plate (A) so that the
applicable cut out for 9.6, 12, 14.4 volt pack
or the 18 volt pack is aligned with the battery
contacts facing the inside of the cut out.
B
A
SPECIFICATIONS
Light Source Semiconductor laser diode
Laser Wavelength 630 – 680nm Visible
Laser Power <5mw, CLASS IIIa LASER
PRODUCT
Rotation Speed approx. 600 rpm
Self-Leveling Range ± 5°
Indoor Visible Range 200' (61m) diameter
Range with Detector 1500' (450m) diameter
Level Accuracy ± 1/8" per 100'
(± 3mm per 31m)
Power Source 9.6V–18V D E WALT batteries
Operating Temperature 23°F to 122°F (-5°C to 50°C)
Storage Temperature -4°F to 158°F (-20°C to 70°C)
Water Resistant IPX4
Usage Indoor and Outdoor
Altitude Up to 6560' (2000m)
Maximum Relative 95%
Humidity
Rated Pollution Degree
2