Electrolux EWG 14740 W - Manual (Page 36)

36 electrolux installation
If it is too short and you do not wish to
move the tap, you will have to
purchase a new, longer hose specially
designed for this type of use
.
Note !
Installation should comply with
local water authority and building
regulations’ requirements.
The appliance must be connected
to a cold water supply.
A minimum water pressure of 0.05
MPa (0.5 bar) is required for safe
operation of the appliance.
If you cannot make the cold water
connection direct from the rising mains,
you may be able to operate the
appliance from your cold water storage
system.
There should be a minimum distance
of 5.02m (16.5 ft) between the
appliance’s inlet and the bottom of the
water storage tank.
Water drainage
This appliance is designed to be
permanently plumbed into your home's
drainage system using one of the
following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the
drain hose using the «U» piece
supplied.
“U” piece
supplied
P1199
Place the drain hose into your
standpipe, which should have an
internal diameter of approximately
38mm thus ensuring there is an air
break between the drain hose and
standpipe.
When discharging into a standpipe
ensure that the top of the standpipe is
no more than 90 cm (35.4'') and no
less than 60 cm (23.6'') above floor
level.
The drain hose may be extended to a
maximum of 4 metres.
An additional drain hose and joining
piece is available from your local
Service Force Centre. The joining piece
must have an internal diameter of 18
mm.
If your drain hose looks like this (see
below) you do not require the «U»
piece. Just push the hose firmly into
the standpipe.
P1039
3 pin
Min.
60 cm (23.6”)
Max.
90 cm (35.4”)
P1074
30 cm (12")
38 mm (11.2”)
standpipe
diameter
132973570 EN.qxd 07/05/2007 13.51 Pagina 36