Before use, Insert / change battery, Operating instructions – Tronic H12276 User Manual
Page 26: Measuring d, c, aa and aaa battery, Measuring 9 v battery

26 GB/MT
Safety Information / Before use / Operating instructions
J
Remove a spent battery immediately from the device. There is an increased danger of leaks!
J
Batteries must not be disposed of in the normal domestic waste!
J
Every consumer is legally obliged to dispose of batteries in the proper manner!
J
Keep batteries away from children; do not throw them in the fire, short-circuit them or take them
apart.
J
If the above instructions are not complied with, the battery may discharge themselves beyond
their end voltage. There is then a danger of leaking. If the battery have leaked inside your
device, you should remove them immediately in order to prevent damage to the device!
J
Avoid contact with the skin, eyes and mucous membranes. Any parts of the body coming into
contact with battery acid should be rinsed off with copious amounts of water and / or a doctor
contacted if necessary!
Q
Before use
Q
Insert / change battery
j
Remove the cover of the battery compartment
3
by pulling it off in the direction of the arrow
(see illustration).
j
Insert a micro battery (AAA 1.5 V).
Note: Please observe the correct polarity. This is indicated in the battery compartment.
j
Then close the battery compartment again.
Q
Operating instructions
Q
Measuring D, C, AA and AAA battery
j
Place a battery of the type D, C, AA or AAA in the battery tester (see fig. A).
Note: In doing so, please observe the correct polarity. This is shown on the battery tester.
Note: Please ensure for proper contact between the battery and the battery tester.
j
Secure the battery by means of the extendable contact arm
1
(see fig. A).
j
Read the voltage of the connected battery using the voltage display
5
and the 1.5 V scale
4
.
Q
Measuring 9 v battery
j
Position the 9 V battery on the test contacts
7
(see fig. B).
Note: In doing so, please observe the correct polarity. This is shown on the test contacts
7
.
Note: Please ensure for proper contact between the battery and the test contacts
7
.
j
Read the voltage of the connected battery using the voltage display
5
and the 9 V scale
6
.